Some people will tell you that scrubbing is the best, others will say that rubbing/isopropyl alcohol makes the contacts rust. Ling story short my 1.5K Board is fine and isopropyl is S+ teir safe for cleaning electronics case closed. 70% grade from soaking up moisture it will still evaporate at room temperature almost instantly. (It sucks water up like a super sponge but unless it’s at like. Even removing heat syncs cleaning off them and the thermal paste (replaced it after of course!!) inbetween and under every diode capacitor every single relay followed the leads from start to finish etc etc scrubbed the infrastructure let it dry (takes about 2 seconds since it is miscible with water then will evaporate at room temperature because the kinetic energy at room temperature is enough to overcome attraction of the molecules causing them to disburse into the air rather then stay a liquid. The timestamp is only as accurate as the clock in the camera, and it may be completely wrong.Hi I have a RTX 3060 graphics card in my rig my daughter managed to spill coffee on it i immediately disconnected all power removed internal battery and proceeded to clean the entire board top to bottom LITTERALLY TOP TO BOTTOM BOTH FKING SODES….

If the file has been modified from its original state, some details such as the timestamp may not fully reflect those of the original file.

This file contains additional information such as Exif metadata which may have been added by the digital camera, scanner, or software program used to create or digitize it.

Nintendo nes cleaner